Step 1: Enable Interzone Replication

• Log into MyAccount
• Open up the VDC that has the VMs you wish to protect via SecondSite Interzone replication.
• Select Replicate with SecondSite Interzone and continue .

Step 2: Order

Select the number of VM's you want to protect and the Zone you want to use as your recovery location (Endpoint)

Step 3: Purchase

Follow through the payment gateway and confirm your selection.

Step 4: Secondsite Interzone VDC Information

Go back to your MyAccount page and witness that a new VDC with the prefix SS is being provisioned and appears as below.

As you can see it is highlighting a few important items;

• Interzone -    (Your Protected VDC Name)
• Replication - (Number of VMs and VPGs Protected)
• Licenses -      (Licenses and Extra storage ordered)

Take note - No VM's will be visible under failover vms and  your SS VDC till FAILOVER

Step 5: Firewall requirement

Default - If the default NSX-T firewall is sufficient (In most cases) - Go to Step 6

Excluded - If you require a BYO firewall, please following the following process 

• Log a Ticket at Zettagrid Support  -  support@zettagrid.com
• Ticket information to Include:  Example 
  • Secondsite Number  (SS_1175368)
  • Secondsite Zone       (Brisbane)
  • Account number       (214xxxxxx)
  • Public IPs                   (Required Amount)
  • Internet Traffic           (Any specific requirement? - Used on failover and can be resized) 

• Continue with Step 6 while waiting for support to create your Internet uplink and public IP details

Step 6: Configure your Secondsite Interzone Service 

Configure Networks

Log into your SS_ VDC and add networks required     

• NSX-T Firewall
  • Live Failovers - Routed Network (Connected to Firewall)
  • Test Failovers - Isolated Network  

• BYO Firewall
  • Live Failovers - Isolated Network (Connected to Firewall)
  • Test Failovers - Isolated Network  

Please note: Secondsite Firewalls

NSX-T or new BYO Firewall - If you have advanced firewall rules or NAT rules setup in your production VDC then you will need to also create these on the new SecondSite instance as it is entirely separate from your production VDC. 

Replicated BYO Firewall - Possible config and license changes would be required

Select your VM's to be protected 

Go to Manage located on the right of your SS service portal and select  Protect VM's

Select Yes to the VM or vApp you want to protect and complete the IP and Network section before protecting

Step 7: Confirm Protection   

Log into your SecondSite services via MyAccount and confirm Protected VM's and SLA's

Request protection process can take several hours to complete. (Initial Replication and config)